Typical prices for an off grid cottage

 

Most panels intended for grid tied systems panels have 72 cells or 60 cells. The size of 60 cell panels varies one or 2% by manufacturer. 72 cell panels are larger as a group. Off grid only panels intended for 12V systems have fewer cells, typically 30 cells and are smaller and are much more expensive in terms of $ per Watt.

 

Off Grid Base Cottage System

 

This is a base system that can be expanded smoothly to provide extra capacity by adding panels and 2 more 6V batteries in series/parallel. There is a supported configuration for a total of 2, 3, 4 or 6 panels. This system is for a very small electrical load, for very frugal living. It is too small a capacity to recommend it for 4 seasons living or for all year residences. It does use all cUL or CSA approved parts and if installed correctly is capable of meeting the electrical code requirements for safety.

This system delivers a high quality pure sine wave power, that is suitable for computers, TVs and all picky electrical appliances. I started to build this using 30 cell off grid type of solar panels, and then after analysis determined that It could be built with 60 cell panels that are produced in very high volume for grid connected systems for the same price. This reduced the price by a few dollars while more than doubling the panel total wattage. The 640W panel capacity is around the minimal size that could provide power to a habitation. This is capable of generating on a sunny day about 8% the capacity of a average modern Ontario grid connected home that uses about 24000W per day. Normally an off-grid house system is designed to run for four days without sun, on a fully charged battery. Therefore this system would deliver about 4% of the daily power used by an average home over a 4 day period.

It stores 4.6 kWh of energy if the batteries are discharged to a maximum depth of 80%. That is 1.15 kWh per day over a 4 day period.

It uses top of pole ground mounting so that it can be pointed due south. 2 panels /pole

It uses a prewired panel that encloses all the critical parts and supplies the required circuit breakers. There are no exposed wires to pose a safety risk and it is much neater in appearance. Only the battery is a separate item.

Qty Manufacturer  Item
1 Midnight Solar 2.8 KW, 12 V, Midnight E-PANEL, ALUM, WHITE, includes Magnum MS2812 Pure sine waver inverter.
1 Midnight Solar E-panel lightning protection add on for DC and AC protection
1 Midnight Solar e_panel add on Midnight Classic 150 charge controller & breaker
1 TEN FOOT, 4/0 CABLE PAIR FOR >2500W
2 Hanwa HES 60 Cell Mono 320W 
1 MALE/FEMALE PV WIRE, 10 M, (PR)
1 Midnight Solar MNPV6 enclosure COMBINER BOX, for 6x 150 VDC breakers, or 2 x 600 VDC fuses
1 Midnight Solar DIN RAIL BREAKER, 15 A, 150 VDC
2 Surrette Surrette S-480 6V 480AH, flooded lead acid battery, 51kg
1 BATTERY INTECONNECT #4, 16 IN
1 FastRack Fast Rack Top of Pole Mount for 2 x 60/72 Cell Module 3" Collar
Total Parts $9,016.09
Shipping, without lift gate delivery $0.00
HST $1,172.09
Total  $10,188.18

What is missing?

These prices are for parts only, and do not include installation or shipping.

A good quality generator is essential for long battery life, to recharge the batteries after they have become discharged and there is no sun available to provide a charge, due to night time, or an extended period of cloudy days. If batteries are not immediately recharged, they will start to sulphate, which shortens their lifetime. The best generators for off grid use are propane powered, and are designed for unattended automatic starting. The budget gasoline powered generators that you see at the local hardware stores are not recommended, and can't protect the batteries when unattended, since they require manual starting. They could only be used when the building is constantly habitated, and someone is ready to get up in the middle of the night, and start the generator when the battery voltage drops to the minimum permitted value.

An automatic generator start module is not included in the inverter, it is an extra module that can be added (ME-AGS-N Network). This should be ordered if a propane remote start generator is installed.

A fan to ventilate the batteries when they are charging. This is required for Flooded Lead Acid batteries, but not for sealed AGM or Gel Lead Acid batteries. Flooded lead acid has been selected as is is the most cost efficient type of battery for solar service. AGM batteries for a similar capacity would be more than twice the price, and would add about $900 before taxes to the cost of the parts.

A battery enclosure to protect people and pets from the batteries and permit ventilating the batteries to the outside of the building.

The wires from the weatherproof combiner box mounted on the pole to the inverter e-panel inputs. These should be run inside conduit or poly pipe underground to the edge of the building.

It also does not include items that can be purchased at a hardware store or electrical supplier.

Other Limitations

This only supplies 120V AC, and not 120/240 split phase that is used in hydro connected houses. Therefore only 120VAC appliances can be used. (Some types of submersible water pumps that run on 240V)

Expansion Limits

The Midnight Classic 150 Charge Controller can handle an expansion to up to 6 of the specified solar panels, while the battery voltage remains at 12V. If the battery voltage is changed to 24V, then the charge controller can handle more panels but the Magnun inverter is 12V only and would need to change to switch to 24V which would be a major expense.

The battery can be expanded in capacity by either replacing the batteries or by having a series parallel array of batteries. Paralleling more 12V battery strings to handle higher currents gets expensive and is rarely done. The wire sizes start getting very large and hard to work with. For practical systems that deliver higher power to their loads 24 and 48V batteries are more practical so that circuit breakers can be kept to 125A maximum.

Caution About Bargain Priced 12V Solar Systems

There are temporary systems that are sold at well know Canadian retailers which seem to cost much less for this amount of power. These are made in China, are not CSA approved, and have the following issues. They do not deliver utility grade sine wave power, (they deliver Modified Sine Wave power) and they can't be expanded to add more panels and batteries, as they have very limited electronics components. They use panels designed to charge 12V batteries. The charge controller won't work with the 230-350W 60 cell panels that are very attractively priced for grid tied systems. They also would not pass an ESA inspection, due to the none CSA approved panels, wiring and electronics. They also don't have any mounting hardware to securely mount the solar panels. They are intended for temporary use at a hunt camp or a tenting trip, not for permanent use.